Home > Knowledge > Content
What material is the display stand made of?
- Jun 20, 2018 -

The product that makes with organic glass is beautiful, beautiful, glittering and translucent get rid of appears, very lovely. Many teaching AIDS, toys, decorations, billboards and display frames are made of organic glass. However, how is organic glass processed? Many of my friends don't know very well. Today I'd like to introduce you to the process of organic glass products.

I. classification of organic glass materials

Organic glass is divided into three types: plate, pipe and bar. In terms of color, in addition to colorless transparency, there are red, orange, yellow, green, blue, purple, black, gray and other colors.

1. Plate: it is a plate material, its thickness is from 2mm to 10mm, and the specification of the whole plate is generally 1200 x 1800mm, which can be selected as required.

2. Pipe material: according to the shape of the cross section of the pipe, it is divided into round pipe, square pipe and plum blossom pipe. The inner diameter of the round pipe is from 5mm to 100mm, and the wall thickness of the tube is from 1mm to 4mm. Square pipe and plum flower pipe also have different specifications. Their length is usually about one meter.

3. Rod: the diameter of the round rod is from 10 mm to 50 mm, and the length is about one meter.

Organic glass display stand products

Ii. Processing methods of organic glass

This is a linear cutting method of organic glass. The method is to place the ruler on the sheet material to be cut. The edge of the ruler coincides with the cutting line and fix the ruler. With a hook knife (specially used for cross cutting tool, tool shop stores) feet along the edges of drag, will be on board to cut grooves, at about half the thickness of the grooves depth, can fold. When folding, it is necessary to move the board so that the slot drawn by the hook coincides with the edge of the table. One hand is pressed against the board in the table, and the other hand is holding the board outside the table. The organic glass will break neatly from the hook position.

2. Saw: use saw to cut material or shape, cutting line can be straight and flexible. There are special vibration saws, miniature saws (which will not hurt hands), but also steel saws and wire saws. Sawing process organic glass, fell to make sawdust, because sawdust in friction hot melt glue on the sawtooth blade, lose the sawtooth effect, korah slowly, avoid overheating saw blade sticking to sweep to sawdust sawdust or brush. As the edge of the sawing material is rough, it must be polished smooth with file and sandpaper. Cut off pipe and bar materials commonly used.

File: file is a file. File is required in the following three cases :(1) the edge of the sawed material, (2) the rough embryo is slightly larger but is inconvenient to be cut by saw, and the file is used to fit the required size. (3) remove sharp edges and corners to make them smooth and feel good.

4, heat cutting, are generally use special vibration saw, or laser cutting, but should pay attention to the outside of the finished product line cutting, leave room for fine processing, otherwise after fine processing out smaller than the size of the requirements.

5. Hot bending: if you want to bend the plate at an Angle. For example, to bend at a right Angle. You must use a hot bender (as described in this website), place the material on the hot bender and bake until soft, then place it on the edge of the table and bend it.

Related Products